Panel dividing center, which is available in the versions SP, SPT and PF. Regarding the controller of the machine, there is a selection of MCL or G-Drive.

The model SP features the possibility of the automatic loading from the front with grippers, wich are equipped with floating bearings, and whose bottom finger is moveable for the clamping of the pack of panels until the last edging cut. Supporting tables unter the pusher, equipped with roller segments, avoid damaging the panels in the transport process.

The model SPD can be loaded from the lifting table automatically with the help of the grippers. This plant achieves a high cycle-speed because of the patented system of grippers. The lower fingers of the grippers are retractable, so that a panel pack can be savely taken over from the lifting table without additional transition implements and without damaging the panels.

The model PF is a version for the sizing of individuall seeks of panel with soft- or postforming-edges, but also for straigt workpieces with had been coated with the near or other coatings - often in the version of a cross-cut saw. This model can be set in a line or used as a single machine. In the case of a line it achieves the high-production performance.

• Versions:
• G-Drive also see R.T.G. G-Drive
• G-Drive 2D also R.T.G. 2D
• G-Drive 3D also see R.T.G. 3D
• De Luxe Enclosure: with a sliding door for the loading of the stack from the sight as well as covers of the flotation tables
• As an option available:
• covering at the pressure beam
• side aligner with 2 rollers
• STLD aggregate for thin panels
• device for mitre cuts
• alignment laser
• electronic adjustment of the scoring unit for the height and the side-adjustment even if the tool is in operation, with a visually digital display
• device for the performing of grooving, with changeable groove-depth in the automatic cycle
• PF-scoring unit attached to the sawing carriage (only Prismatic 201 and 301)
• additional scoring unit for post forming for the splinter-free cut of workpieces with applied edges (post- and softformed)
• loading by vacuum lifter
• turning device
• optimization software Optisave