Corner rounding unitAggregate on edgebanders for the rounding of the corners of plastic edges and edges of posts and softformin parts. ApplicationThe workpiece corners are sharp after the edge banding. Follower rolls recopy the corners of the workpiece leading and rear edge. So the profile of the workpiece is transfered by milling to the workpiece corners. As the the workpiece edges were already rounded by the radius milling unit, the rounding is applied to the corners or copied. StructureDepending on the level of the Edgebander and the manufacturer Corner rounding units can be constructed very differently. The motor has to be able to move along the corner with its cutting tool. Furthermore the motor has to move vertical an horizontal simultaneously.This is possible by pivoting arms, by guidance on horizontal and vertical guides or by mounting the engine in a horizontal metal ring, which also serves as a guide. The scanning of the rounded edge of the workpiece made by a following disc. VersionsMost of the manufacturers offering depending on the feed rate Copy corner units with one, two or four engines. Corner units can also have the additional function as a radius milling unit like the Multifunctional trimming unit with corner rounding from Brandt. In highly automated machines sometimes the tools are changeable with a automatic tool changer.
Toolchanger exists only for 2-motor edgerounding units (state 2018)
Alternative terms
|
880
618
434
184
179
131
203
322
188
150
125
62
132
13
31
96
97